Five minutes, six steps, zero tools required.
Dressing a humanoid robot is not complicated, but it does require preparation. The robot must be powered down or in maintenance mode. Active actuators will move during fitting. This damages garments and creates a safety risk for the operator.
You need three things: the garment, a flat surface (or charging dock) to support the robot, and the platform-specific fit guide that ships with every Maison Roboto order. The fit guide shows sensor locations, charging port positions, and joint clearance zones for your specific robot model.
Every humanoid robot has external sensors that cannot be blocked. LIDAR arrays, depth cameras, proximity sensors, and infrared emitters each occupy specific positions on the chassis. Your Maison Roboto garment has sensor-transparent mesh panels pre-positioned for your platform. Before pulling the garment on, verify that the mesh windows align with the sensor locations on the fit guide.
On Tesla Optimus, the primary sensors sit on the chest and head. On Figure 03, sensors are distributed across the upper torso and shoulders. On 1X NEO, the main array is centered on the chest cavity. Each platform is different. Check the guide.
Jackets, shirts, and upper-body garments go on first. Open all magnetic closures before fitting. Slide the garment over the head or, if the design permits, open it fully and wrap it around the torso from behind. Pull each arm through its sleeve one at a time.
Do not force fabric over joints. If a sleeve catches on a shoulder actuator housing, back it off and re-angle. The fabric should glide. If it does not glide, you are pulling at the wrong angle.
Maison Roboto garments use neodymium magnetic closures. Bring the two closure edges within 3mm and the magnets engage automatically. You will feel the snap. Run your hand down the closure line to confirm all magnets have seated. Decorative buttons are pre-attached and do not need threading.
Magnetic closures are rated for 500,000 engagement cycles. They will outlast the fabric.
Trousers and lower garments go on next. Step each leg through its opening. Waistband closures are magnetic. For robots with a charging port on the lower torso or hip, verify the port access panel on the garment is properly aligned. Every Maison Roboto trouser includes a hidden port flap that opens without removing the garment.
Power the robot to maintenance mode (low-torque, slow-speed articulation). Run each joint through its full range. Watch for fabric bunching at the elbow, knee, and shoulder. Listen for fabric catching on joint housings. If the garment binds at any point, adjust the seam position or loosen the closure tension.
A properly fitted Maison Roboto garment allows full ROM on all joints. If you experience binding, contact our atelier. The fit profile for your platform is stored in the configurator and adjustments can be made for your specific unit's tolerances.
Confirm sensor transparency. Check that all mesh panels sit flush over sensor arrays. Verify the charging port is accessible. Straighten the collar, adjust the trouser break, and the robot is dressed.
Total time for an experienced operator: under five minutes. First-timers take ten.
Daily-use deployments should rotate between three garments on a weekly cycle. Machine wash after each rotation on a cold gentle cycle. Hang dry. Do not iron directly on sensor-transparent mesh panels. Store garments flat or on wide-shoulder hangers to maintain shape.
Garments last six to twelve months under daily use. Order replacements through the configurator using your saved platform profile. The pattern is stored. Reorders ship in two weeks.
Most humanoid robots cannot reliably dress themselves yet. Current end-effectors lack the dexterity for buttons, zippers, or pulling fabric over joints. A human operator dresses the robot, typically in under 5 minutes using magnetic-closure garments.
Yes. Always power down or put the robot in maintenance mode before fitting garments. Active actuators can move unexpectedly during dressing and damage the garment or injure the operator.
For daily-use deployments, rotate between three garments on a weekly cycle. Wash after each rotation. Garments last 6 to 12 months under this schedule before replacement is needed.
Configure your robot's wardrobe. The fit profile auto-adjusts to your platform.